How to configure Discovery Scanner Agent

You can refer to these 2 KB articles on how to setup the scan jobs

https://beyondtrustcorp.service-now.com/csm?id=kb_article_view&sysparm_article=KB0017147

https://beyondtrustcorp.service-now.com/csm?id=kb_article_view&sysparm_article=KB0017022

It’s so simple, refer this article https://beyondtrustcorp.service-now.com/csm?id=kb_article_view&sysparm_article=KB0017147

Hello Howard and Chittaranjan,

Thank you for your reply!!

I did check above articles. I am blocked at below step - 

5. Choose a scan agent. If more than one is selected, the targets are split between the agents.

I am not able to see any scan agent in list to select.

Hi Prasad,

Have you configured the discovery scan using cmd commands? Navigate to your Discover Scan folder path then open cmd and run the following commands:

btdiscovery getc

btdiscovery setc

btdiscovery testc - result must be OK

btdiscovery gete

btdiscovery sete

btdiscovery teste - result must be OK

Hello Everyone,

Thanks for response and providing solutions, I could be able to figure out issue as password agent seemed to be not configured correctly. Now I am able to see the same.

Thanks,

Prasad

Glad the issue is resolved. Have a good one.