Hello,
We are currently integrating credential injection from Password Safe into PRA for Cisco devices using the Shell Jump method.
Users are able to successfully authenticate and access the devices with the injected credentials. However, when they attempt to enter "enable" mode to perform configuration changes, the system prompts for the password again.
At this point, no credential injection prompt or window is displayed, so users are required to manually enter the password. Since the credentials were injected automatically during the initial login, the users do not have visibility of the password and cannot proceed.
There is any feature or recommended approach that allows re-injecting or reusing the credentials once inside the shell session (for example, when escalating to enable mode).
Thank you.
